
Spring Repair
The most common reason a door stops lifting. Springs wear by cycle count, and a garage used as the family entrance racks up cycles quickly.
Spring RepairPhoenix Garage Door Experts repairs springs, cables, rollers, tracks, panels and openers, and installs new doors across the Phoenix area. Start with the symptom you are seeing and the right service page will explain what the visit covers.

The most common reason a door stops lifting. Springs wear by cycle count, and a garage used as the family entrance racks up cycles quickly.
Spring Repair
Motors, logic boards, gears, remotes, keypads and safety sensors all fail differently. The test starts with the symptom, not the part.
Opener Repair
Frayed cables and seized rollers pull a door out of square. Both get replaced in matched sets so the door tracks evenly.
Cable and Roller Repair
A door off its track needs to be secured before it is moved. Forcing it with the opener usually bends the track further.
Off-Track Repair
One damaged section does not always mean a whole new door, but the model and finish have to still be available to match.
Panel Replacement
Measuring the opening, headroom and side room comes before choosing a style, especially where an HOA reviews exterior changes.
New Door Installation
Roll-up and sectional bays at shops, yards and warehouses, serviced around the hours your business actually runs.
Commercial Door RepairMost homes in the Phoenix area are slab-on-grade stucco with an attached two- or three-car garage facing the street, and that garage is the entrance the household uses. Doors here open and close far more often than the tidy averages in a manufacturer's manual, so springs and rollers reach the end of their service life sooner than owners expect.
Heat is the second factor. An uninsulated garage in July sits far hotter than the outside air, which dries out rollers and hinges, hardens the bottom seal and is hard on opener electronics. Monsoon dust storms add fine grit to every track and hinge in the door.
If you are weighing a bigger change, read repair versus replacement, then find your city on the service areas page or see how a visit is arranged.

If the door will not move at all, start with spring repair. If it moves but the remote or wall button is unreliable, start with opener repair. If the door is crooked, grinding or sitting outside its track, treat it as an off-track problem and stop using it.
Not sure which applies? Describe the symptom on the service request page or read the repair guides first. Businesses with roll-up bays should go straight to commercial door repair.
Tell us what the door is doing now so the right parts and time can be planned.